- #Zyxel nsa310 firmware update usb drives how to
- #Zyxel nsa310 firmware update usb drives serial
- #Zyxel nsa310 firmware update usb drives Pc
The rootfs partition is recommended to be type Ext3 (this is not a hard requirement, ext4 should boot OK, but Ext3 will ensure no problem).
The partition that contains the rootfs must be labeled rootfs The partition that contains the 2 kernel files must be partition 1 in a disk drive The 2 kernel files are /boot/uImage and /boot/uInitrd. There must be only one partition among all partitions from all drives that contains the kernel files. In this case, section C below can be used to tailor the envs to your specific configuration. The scanning logic and default envs were set to automatically boot the box with the following required configuration:įor whatever reason, if you can't set up your configuration to satisfy the following 4 requirements, then don't flash this defaut envs image. The disk drives could be any type (usb, sata, sd card). This default envs image supports booting with multiple disk drives (and hubs) attached. In the uBoot Tutorial are there three different (A, B, C) tutorials, wich one is for the uboot installation with the usb-stick on the first start? How can I check for bad blocks in the first 1MB? I unpack the to the /tmp folder on the usb stick I logged the output from printenv to a logging fileĥ.
#Zyxel nsa310 firmware update usb drives serial
I startetd a serial connection to the NAS mainbaord an interrupted the autostart and type printenv. The can't control the cat /proc/mtd because the system is not booted yet, but the stnadard fw_Env / mtd0 is 2 MB.Ģ. I controlled the /etc/fw_env.config on the usb stick, everything is okay. no need of changes because I want to update uBootġ. sudo tar xvfj Debian-4.12.2 -C /run/media/icke/rootfsĤ. Formated my USB stick (Scandisk 32GB) complete with ext3 and named it rootfsĢ. I followed the tutorial from the Linux Kernel / Debian site ġ. I think I need a Linux on the NAS but that is the goal, I haven't had this for now.ĭo I need a working Linux on an USB-Stick to update uBoot or has the original firmware from Zyxel the possibility to run the described commands for updating uBoot on the NAS? But what is the next step the commands described in the tutorial are not known in the serial connection.
#Zyxel nsa310 firmware update usb drives how to
I read the uBoot tutorial many times but I didn't know how to start. That is the uBoot version of the original firmware from Zyxel. I interruppted the autostart an the command "version" gave me the following output:
#Zyxel nsa310 firmware update usb drives Pc
I detached the NAS and only have the mainboard in front of me with the power cable, the network cable and the serial cable connected to the board.įrom my PC (Linux) I have a serial connection via "screen" to the Zyxel mainboard. I have installed the latest original firmware from Zyxel. I have an old Zyxel NAS325v2 and want to use a new Debian on it. First of all, sorry for the question but I don't understand the tutorial.
0 kommentar(er)
